Vintage Japanese 'Badged' Zig Zag and Straight Sew Sewing Machines
#383
Member
Join Date: Nov 2017
Posts: 1
Originally Posted by [email protected]
Just got this beauty yesterday and would like any info anyone can provide about it. Like what year it was made or anything like that. The model number is #752, Serial #3045. On the bottom it has J-C5 stamped into it. Other than these id's there is no other marking on it.
[ATTACH=CONFIG]573097[/ATTACH]
[ATTACH=CONFIG]573097[/ATTACH]
#385
Member
Join Date: Nov 2017
Location: St Louis, MO
Posts: 11
I'm back with another question. Was trying to do a little work with this machine and ran into a question. The needle is to the left of the center on the foot. It sews ok but I find it hard to concentrate on my line and the work tends to wander. You can see in the picture where the needle is not centered. The only way I can seem to center is by adjusting the zig zag but then I don't get a straight stitch. The only other thing I can think is perhaps the wrong foot is mounted (I only have the one). Still learning about this machine and being a novice at sewing does not help. Thanks
#386
Banned
Join Date: Aug 2014
Location: Victorian Sweatshop Forum
Posts: 4,096
Nope your machine is fine and has the right foot. You have what's called a left-homing or left needle machine. Straight stitch is done in left needle position. Great for garment sewing, not so much for quilt piecing.
Cari
Cari
#388
Member
Join Date: Nov 2017
Location: St Louis, MO
Posts: 11
I did my own modification today to center the foot. Removed the two tiny screws on the foot and replaced them with a pin and offset the foot slightly to the left. then I opened the hole a little to the right with a small grinder in case I still want to use the zig zag. End result is I am very slightly to the right of center but that is ok with me. Gives me a much better view while straight line sewing.
#390
Member
Join Date: Nov 2017
Location: St Louis, MO
Posts: 11
Did some sewing on some vinyl fabric the other day. While my talent is still lacking, the machine performed exactly like I hoped it would. I'm trying to make a custom seat cover for a old motorcycle. Nothing fancy but it has to pull tight over some foam and a metal frame. I was just happy to see the machine work this well on a heavy material. If my results turn out good, I will post a picture.
Thread
Thread Starter
Forum
Replies
Last Post
Tank
For Vintage & Antique Machine Enthusiasts
11
04-11-2024 05:38 AM
miriam
For Vintage & Antique Machine Enthusiasts
208
06-09-2023 05:10 PM
amandalembesis
For Vintage & Antique Machine Enthusiasts
3
03-11-2019 07:48 PM
daisywreath
For Vintage & Antique Machine Enthusiasts
14
12-29-2012 08:53 AM