Will the Real 15 clone please stand up
#121
Power Poster
Thread Starter
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
Well Miriam and Joe, I didn't have to use anything but sewing machine oil to un-stick the Electra. I soaked her with sewing machine oil for 4 days. I kept trying to turn her wheel with no luck until last night. Last night I got the wheel to make a half turn. Today when I tried, I did a whole very slow and stiff turn. I oiled again, set her in the sun and tonight she is fully funtional! I haven't threaded her yet to see if she sews, but I have no reason to think she wouldn't sew! It amazes me how stuck that machine was from just neglect. No rust. Just dried up oil, or probably no oil was ever applied to her!
Nanchy
Nanchy
#122
Super Member
Join Date: Feb 2012
Posts: 8,091
Nancy,
Glad you got it freed up. When I brought my Franklin home it wouldn't hardly move. It took a lot of effort for little result. I hosed it with Liquid Wrench and in a little while she was spinning freely. Now with oil and cleaning she sews soooo easy. Which is good, cos Mrs. Franklin is a treadle machine.
Joe
Glad you got it freed up. When I brought my Franklin home it wouldn't hardly move. It took a lot of effort for little result. I hosed it with Liquid Wrench and in a little while she was spinning freely. Now with oil and cleaning she sews soooo easy. Which is good, cos Mrs. Franklin is a treadle machine.
Joe
#124
Power Poster
Thread Starter
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
Just get a different motor and wires - there is a screw that holds the motor on - unscrew it and put the new one on and adjust your belt.
#129
Power Poster
Thread Starter
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
here is one I found - it looks almost like new. I have found that the ones that look like they were never used probably weren't (duh) but they usually have some issue or another - probably WHY they weren't ever used. This one had some tension problems and the bobbin case pops out all the time. Once it was adjusted it sews very nice. BTW it is not missing the slide plate - it is just so shiny and it just reflects the fabric real well [ATTACH=CONFIG]325289[/ATTACH]
#130
In my 15-91 adjusters manual Singer says to use kerosene to clean out darkened, thick oil or grease. If Singer say it's ok it must not hurt the machines at all.
Nancy,
Here is a trick I've used on a couple machines that were really badly gummed up. Use Hoppe's #9 gun cleaning solvent.
It's mostly kerosene with some additional ingredients. It works very well for cleaning the yellow brown oil and nicotine off of the chrome parts. And limited contact won't hurt ..... as least it hasn't hurt any of mine .... the paint or decals.
I use it mostly to removed the old oil from the presser foot and needle bar.
Joe
Here is a trick I've used on a couple machines that were really badly gummed up. Use Hoppe's #9 gun cleaning solvent.
It's mostly kerosene with some additional ingredients. It works very well for cleaning the yellow brown oil and nicotine off of the chrome parts. And limited contact won't hurt ..... as least it hasn't hurt any of mine .... the paint or decals.
I use it mostly to removed the old oil from the presser foot and needle bar.
Joe
Thread
Thread Starter
Forum
Replies
Last Post
OurWorkbench
For Vintage & Antique Machine Enthusiasts
106
03-14-2016 04:40 PM
olebat
For Vintage & Antique Machine Enthusiasts
14
04-06-2013 03:54 PM