Vintage Sewing Machine Shop.....Come on in and sit a spell
Super Member
Join Date: Apr 2007
Location: North Carolina - But otherwise, NOTW
Posts: 7,940
No, no chemical strippers on this!! My DH is a wood guy, too, (but not so much into refinishing!), and knows not to use chemical strippers. He hates that stuff!!
Super Member
Join Date: Mar 2010
Location: Huntsville, AL
Posts: 2,609
Glenn I am an airhead when it comes to computers. I have no idea of how to put a picture on this computer.
I can not even get it to send me a message when some one post on here. I though I had it set up for instant
messages. Teck stuff and I do not always get along. I have not even figured out my VCR and I have had it
for over five years. It sits unused until my granddaughter comes and put in a movie for me. Kathie
I can not even get it to send me a message when some one post on here. I though I had it set up for instant
messages. Teck stuff and I do not always get along. I have not even figured out my VCR and I have had it
for over five years. It sits unused until my granddaughter comes and put in a movie for me. Kathie
Have any of you run into this...I checked my e-mail and had a reply in this thread. I check in quite often because otherwise it's hard to keep up with the posting. When I click I was sent back to page 2269. Then I couldn't change the page. Weird or what? I closed the page and went back to e-mail and tried again. Right to the last page. Hope it was a one time thing, just starting to figure the new QB out.
Senior Member
Join Date: Jan 2011
Location: Northern California
Posts: 559
Super Member
Join Date: Aug 2011
Location: Millville, NJ
Posts: 1,835
This is pretty much a pipe dream, don't think I could chalk up the shipping unless we could get a "Pony" from Japan to NJ going.
Jon
Jon
Junior Member
Join Date: May 2011
Posts: 192
I've had somewhat the same problem, try to go to next page and doesn't do anything. Would have to go to new website and then back to get to next or last page.
I have a 328 I've always meant to use in a treadle, but haven't for this reason. The only ZZ treadle I have right now is a Japanese class 15. It's a great machine, but only does ZZ and straight stitches. Would love to try a 319, and probably will!
Thread
Thread Starter
Forum
Replies
Last Post
Stitchnripper
Main
5
10-17-2018 09:01 AM
AngieS
Main
38
10-06-2011 10:06 PM
craftybear
Offline Events, Announcements, Discussions
34
09-09-2011 12:36 PM