Vintage Sewing Machine Shop.....Come on in and sit a spell
Power Poster
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
Super Member
Join Date: Feb 2012
Posts: 8,091
What is with the formatting on this forum? My bigger post above comes out all jammed up. Hard to read and understand. Is that a setting I can change?
Also my direction keys do not work here. Drives me nuts.
At this rate I might as well post without caps, sentences or punctuation.
Joe
Also my direction keys do not work here. Drives me nuts.
At this rate I might as well post without caps, sentences or punctuation.
Joe
Joe, I think so. Am willing to try it anyway. Would like a picture of what these parts lok like as I have zero 99 manuals with either of my other 99s. BTW, what is an oscillating hook? Where do you need the screw from?
Super Member
Join Date: Mar 2010
Location: Huntsville, AL
Posts: 2,609
Mz Johnny where do you get 16x1 needles for your Phoenix? Is there an alternate needle that can be used.?
Last edited by Glenn; 03-07-2012 at 06:20 PM.
What is with the formatting on this forum? My bigger post above comes out all jammed up. Hard to read and understand. Is that a setting I can change?
Also my direction keys do not work here. Drives me nuts.
At this rate I might as well post without caps, sentences or punctuation.
Joe
Also my direction keys do not work here. Drives me nuts.
At this rate I might as well post without caps, sentences or punctuation.
Joe
Joe, Did you get that tension dial problem fixed on the 401a? I posted a suggestion. Did you understand it and give it a try?
Super Member
Join Date: Jan 2010
Location: Outer Space
Posts: 9,319
Joe, "ham fisted, bubba". Too funny! Is it worth totally disassembling to see of some of the internal parts are bent? I would be tempted to go that route as a last resort. Nah, the hammer would be my last resort. Or a BB gun.
Super Member
Join Date: Mar 2010
Location: Huntsville, AL
Posts: 2,609
Johnny hope to see this Aug at the TN TOGA again. This time I will come prepared if that is possible for me
Thread
Thread Starter
Forum
Replies
Last Post
Stitchnripper
Main
5
10-17-2018 09:01 AM
AngieS
Main
38
10-06-2011 10:06 PM
craftybear
Offline Events, Announcements, Discussions
34
09-09-2011 12:36 PM