How to stop "folding" while quilting
#14
Power Poster
Join Date: Mar 2011
Location: Ontario, Canada
Posts: 41,538
I see it is happening as you try to sew over a already quilted verticle seam. Going over a quilting lines is always a tricky spot. I make a frame with my hands around the foot about a 6 inch circle with my Machinger gloves on. I kind of pull the quilt outwards with my hands as I sew and watch to make it smooths out any extra fabric. If you can't smooth out the surface before you get to the line, you are going to get a pleat or pucker. I try to choose other quilting designs that do not have bisecting lines for this very reason.
#15
Super Member
Join Date: Aug 2011
Location: Texas
Posts: 3,667
I also spray baste. But I only use 505 Basting Spray, as it doesn't gum up my needle, machine, thread, etc. I also haven't had any issues with my Lupus acting up from spraying it. I buy it at Sewforless.com, as that's the best price I've found.
#17
Power Poster
Join Date: Dec 2010
Location: Michigan
Posts: 11,276
You said you pinned really well. You do need a lot of pins. You should be able to put your fist down anywhere on the pinned top and touch at least 2 pins. Also, if you start quilting from the middle out, you may have better results. and last, it looks like you are using a walking foot? make sure you have attached it correctly.
#19
I know it's not always posssible, but I find that when I do cross-hatching on the diagonal I rarely get puckers. Amd as Tartan said, pulling (stretching) the fabric out with both hands as you go will smooth things out pretty well. I am definitely no expert and still need lots of practice.
#20
Super Member
Join Date: Oct 2015
Location: Va.
Posts: 5,753
[QUOTE=kjackson;7402745]Thanks, Rob, it's one of the older ones with the arm that goes over the needle (what exactly does that arm do?)
The arm that goes over the needle bar (actually over the screw that holds the needle clamp in place) causes the foot's moving parts to go up and down in time with the needle, so they act as feed dogs for the top layer of fabric. If the arm isn't placed over the needle clamp screw, then those parts don't work properly.
Rob
The arm that goes over the needle bar (actually over the screw that holds the needle clamp in place) causes the foot's moving parts to go up and down in time with the needle, so they act as feed dogs for the top layer of fabric. If the arm isn't placed over the needle clamp screw, then those parts don't work properly.
Rob
Thread
Thread Starter
Forum
Replies
Last Post
bearisgray
General Chit-Chat (non-quilting talk)
65
02-01-2024 09:04 AM
nanna-up-north
For Vintage & Antique Machine Enthusiasts
13
10-28-2013 12:53 PM
lisalisa
General Chit-Chat (non-quilting talk)
54
02-19-2011 11:01 AM