Singer 411G, spool pin pads?
#32
Power Poster
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
oops sorta clumsy here...
[ATTACH=CONFIG]373361[/ATTACH]
up close
[ATTACH=CONFIG]373362[/ATTACH]
I do not know what the round thing is. It is the same size diameter as the bobbin but a little taller. The throat plate is just like a T&S for chain. I have a surplus of those if anybody needs them.
[ATTACH=CONFIG]373361[/ATTACH]
up close
[ATTACH=CONFIG]373362[/ATTACH]
I do not know what the round thing is. It is the same size diameter as the bobbin but a little taller. The throat plate is just like a T&S for chain. I have a surplus of those if anybody needs them.
Last edited by miriam; 10-29-2012 at 04:18 PM.
#33
The scooping on the back of the needle plate is a little different than the T&S plates, and again, the part number is different. I think I tried the T&S plate in there, because I was curious, and it wasn't a good fit,.. but it's hazy, so I might have just thought about it. Might have run into the BCase. Might not be a problem though for a "regular" BCase...
I find it really interesting though that these 2 machines have such different pieces for the same model.
BTW, I asked the supplier I get my new Singer parts from. They said that the leg cushion for a FW (45780) will work in place of the original "pads", if you convince them a little. I will give it a try when my fresh ones arrive.
#34
Power Poster
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
I'm not sure how that assembles. I do not see a parts number - for all I know it could be a part off a toilet. There is no manual - I do have one I downloaded but there are no details about the bobbin area. Nothing about changing out the throat plate nothing about the round thing - just stringing up the top and leaving out the bobbin.
#35
That is exceedingly weird. The manual I have shows the AK3 plate in use, and the upper threading, but that's it. There is no mention, like you say of other parts. If I thread according to the instructions, and change the plate, it works, but I have a different bobbin case than you do, so I'm not sure what to tell you. Does the round ring fit in where the bobbin would go? Could the slide plate close with it in place?
Might be from a toilet...
Might be from a toilet...
#37
Drama,.. more than car accidents and almost-super-bugs? I thought you'd had your trifecta of bad luck!?!?
That is really weird. I don't know that I've ever seen anything like that with a Singer... or any machine for that matter.
Maybe it's Goth jewellery?
It's a lovely finger.
That is really weird. I don't know that I've ever seen anything like that with a Singer... or any machine for that matter.
Maybe it's Goth jewellery?
It's a lovely finger.
Thread
Thread Starter
Forum
Replies
Last Post
Olik
For Vintage & Antique Machine Enthusiasts
25
08-26-2017 08:42 AM
miriam
For Vintage & Antique Machine Enthusiasts
154
03-12-2014 07:43 AM
ArchaicArcane
For Vintage & Antique Machine Enthusiasts
9
01-19-2013 10:11 AM